adless iptv player
EN

E-NET-MOBILE-OFF: Mobile data is off for Adless

Playback on mobile data is off. Turn it on in Settings, Network, or use Wi-Fi. E-NET-MOBILE-OFF In the player, over the video.

Mobile data is turned off for Adless. E-NET-MOBILE-OFF On the playlist card and the add and edit form, in Settings - Playlists.

What it means

The device is online over mobile data, and Adless has been told to stream over Wi-Fi only. It stops before opening the stream, so no mobile data is used. This is a setting doing its job, not a fault.

Likely causes

  • Settings - Network - Allow mobile data is off. It is on unless someone turned it off.
  • The phone left Wi-Fi without you noticing, for example on the edge of the home network, and moved to mobile data.

What to do in Adless

  1. To watch on mobile data, turn on Settings - Network - Allow mobile data. The hint under it reads “Off means Wi-Fi only.”
  2. To keep it off, connect to Wi-Fi and press Retry.
  3. If you are sure you are on Wi-Fi, check the phone’s own Wi-Fi status. Android can fall back to mobile data on a Wi-Fi network with a poor connection.

The switch belongs to each device: turning it on on the phone does not change it on a tablet, and backup does not carry it.

Why the switch exists

An hour of 1080p IPTV is around 2.7 GB. On a phone that leaves Wi-Fi in the middle of a film, a player that carries on over mobile data can use a monthly allowance in an evening. How much data IPTV uses has a calculator for your own channels.

When it is the provider’s side

Never. The stream was not requested.

Read more

  • How much data IPTV uses, per hour and per month IPTV uses about 0.9 GB an hour in SD, 2.7 GB in 1080p and 9 GB in 4K, but the real figure is your channel's bitrate. How to read it, a calculator, and what else uses data besides the picture.
  • IPTV channel won't load: the causes in order A channel that will not start fails in one of six places, from your connection to the provider's server to the device's decoder. How to check them in order, and what each error means.

Other connection codes